Boilers & Powerplants
Menu
Cyclone Seperator
Boilers
1. AFBC Boiler: Atmospheric Fluidized Bed Combustion
- Multifuel firing
- Optimum Combustion with Staged secondary air system
- Machine welded membrane panel
- Better Steam Purity
- Bed Evaporator design for better reliability
- Pin Studs welded on inbed surfaces
- Overbed as well as Underbed feed system is offered
- Hopper Bottom Design also available for specific application
Operating Range :
Capacity | : Up to 300 TPH |
Pressure | : Up to 160 kg/cm2 (g) |
Temperature | : Up to 5400 |
Fuels | : Coal, Ignite, Rice husk, petcoke, spent coffee ground, washery rejects, low ash Coal, paper sludge, roasted chaff, DOB, bagasse, pith woodchips, biomass |
2. Biomass Fired Boilers
- Continuous Ash discharge
- Grate Driven by hydraulic drives
- Better Steam Purity
- Bi-Drum, Single drum, natural circulation, top supported design
- Three/Two Stage superheater with inter stage feed water spray attemperator
- Even Flue distribution on grate
- Modulating cyclo motor
- Tall Furnace for complete combustion
- Pinhole grate or water cooled pusher grate is offered for specific application
Operating Range :
Capacity | : Up to 180 TPH |
Pressure | : Up to 135 kg/cm2 (g) |
Temperature | : Up to 5400 |
Fuels | : Biomass , Ignite, Rice husk, spent coffee ground, washery rejects, low ash Coal, paper sludge, roasted chaff, DOB, bagasse, pith woodchips and Coal |
Capacity | : 70 TPH |
Pressure | : 66 kg/cm2 (g) |
Temperature | : 4900 |
Type | : AFBC Boiler with Hopper Bottom0 |
Fuels | : Rice husk, Indian Coal and Char |
3. Bi-Drum Packaged / Site Erected Boilers
- High capacity Floor Mounted (HCFM/PFM) boiler completely pre-engineered with packaged design to check for field assembly
- Multiple burners for increased capacity
- Special design of drum internals for high steam purity
- Membrane/Studded wall water cooled furnace construction
- Fully drainable convective superheater
- Fine combustion control and high turndown ratios
Operating Range :
Capacity | : Up to 300 TPH |
Pressure | : Up to 110 kg/cm2 (g) |
Temperature | : Up to 5380 |
Fuels | : All liquid & Gaseous Fuels, waste fuels, tar, hydrogen, refinery gases |
Steam Turbines
Parameters | TXN-FR-1 | TXN-FR-2 | TXN-FR-3 |
Inlet Steam Pressure ( Max/Min ) Kg/cm2 | 6 – 20 | 10 – 32 | 12 – 45 |
Inlet Steam Temp Condition ( Max/Min ) Deg C | 100% Dry saturated /350 Deg C | 100% Dry saturated /400 Deg C (Max) | 100% Dry saturated /400 Deg C (Max) |
Outlet Steam Pressure Max. ( MPa ) Max | 4 | 6 | 12 – 45 |
Generator Out Power ( KWe ) Max | 500 | 1500 | 2500 |
Generator Speed (RPM) | 3000 | 3000/6400/7500* | 3000/6400/7500* |
Maximum Overall Efficiency | 60% | 55-75% | 70-83% |
Inlet Line Sizes | 4 | 4/6* | 6/8* |
Outlet Line Sizes | 8 | 12/14 | 14/16 |
Exhaust Orientation | LH* | TOP | TOP |
Electro Static Precipitaor
- Collecting Electrodes
- Discharge Electrodes
- GD Screen
- Collecting / Discharge Electrode Frames
- Rapping Mechanism with Shafts and Hammers
- Inner and Outer Arms for Rapping Mechanism
- Heating Elements for Hopper and Support Insulator
- Disconnecting Swith Assembly
- Purge Air Assembly
- Structural Bearings

Bag Filter
- Filter Bag
- Filter Cage
- Metallic Cages
- Venturi
- Tube sheet
- Solenoid Valve
- Dust Carrying Valve
- Hopper

Mechanical Dust Collector
- Collecting Tube
- Inlet Guide Vane
- Outlet Guide Vane
- Hopper
- MDC Cone

Wet Scrubber
- Spray Nozzles
- Moisture Eliminator
- Liquid Reservoir
- Clean Air Discharge

Cyclone Seperator
- Blower
- Outer Cylinder
- Blower Outlet
- Cyclone Outlet
- Muffler
- Filters